W18HL
Precision shaft 18h6 as commercial length in Cf53 Ø 18 mm, length approx. 6100mm
Material: Cf53 (1.1213)
Surface hardened: HRC min. 59
Hardening depth: Rht min. 0,6mm
Straightness: max 0,2mm/m
Ground: Tolerance h6
Surface roughness: RA max 0,3
Roundness: 5µm
Sold in 6m increments only
Data sheets from W18HL, technical info (if available) can be found in the Documents folder on the right.
General information about surface hardened precision shafts in Cf53:
The surface hardening process used in the manufacture of these precision shafts results in the outer layer of the material being hardened while the core remains soft and tough. This creates a surface with high hardness that is more resistant to wear than the original material.
