WH20x14-1/3HL
Precision shaft 20h7 -Precision hollow shaft- as 1/3 commercial length in C60 Ø 20 mm, length approx. 2030mm
Inner bore: appr. 14mm
Material: C60 (1.0601)
Surface hardened: HRC min. 59
Hardening depth: Rht min. 0,9mm
Straightness: max 0,2mm/m
Ground: Tolerance h6
Surface roughness: RA max 0,3
Roundness: 6µm
Sold in 6m increments only
Data sheets from WH20x14-1/3HL, technical info (if available) can be found in the Documents folder on the right.
General information on surface hardened precision hollow shafts in C60:
Surface hardening is a process used to improve the surface hardness of workpieces. It involves heating a thin layer of the workpiece and then rapidly cooling it to produce a thin but hard layer. This layer can reduce the wear of the workpiece and extend its service life.
